Its my first time to remove all party for a bige clean up and it feels like not normal to me.
Is it normal that this is so heavy to move?
byu/neont0t inMTB
by neont0t
Its my first time to remove all party for a bige clean up and it feels like not normal to me.
Is it normal that this is so heavy to move?
byu/neont0t inMTB
by neont0t
12 Comments
That should be smooth, the bearings are smoked.
Bearings needs to be replaced.
You have either torqued the bolts down to tightly or the bearings are worn out. Did you remove the piece and put it back on? Have you inspected the bearings? The bearings need to be changed out on occasion depending on how much you ride.
Yes, this is totally normal. If you washer your bike all the time and never replace the bearings.
Normal…..if your bearings need a service, yes.
Okay, thanks. I try to remove it and change the bearings
New bearings. You might as well do all the suspension bearing at the same time. There’s probably a complete bearing set on eBay you can buy.
lol of course not. Time for a linkage service.
hell naw. take out the linkage and inspect your bearings. replace them if they are dead, and if they rotate smoothly, install the linkage and torque it properly
Its either over torqued, or the bearings are shot.
Or maybe both.
Overtorqued assemblies wear faster.
Normal for a hard tail. Send it.
Its super normal if you dont know or care how to maintain yo bike