i just replaced a new chain after it reached .75 and all cogs are great but the smallest cog kinda skips only when im printing really high torque.
found this replacement but its 11t whereas the original cog has 10t – will that work? if so, will 1t make a great difference on final speed? thanks!
by natur3lover
2 Comments
It depends. Do you have typical splined freehub body, XD or microspline? The cogs that are pictured are for a typical splined freehub body.
It will probably work fine. The top speed you would lose depends on your chainring size (I think). There are gear calculators online that will tell you exactly.
Even though the other gears are not skipping, they are probably not far behind that one with wear, so they will likely cause your new chain to stretch quickly and then you will be replacing chains more often until you replace the entire cassette.