Hi everyone, long time lurker first time poster here on Reddit. I just got these Garmin vector 3 pedals and it says I have to use 30nm torque to put them on but how do you turque with a pedal wrench? Sorry if it’s a stupid question but for the life of me I can’t think of something
by ReputationGeneral981
4 Comments
Look up a cros foot wrench. Put that on your torque driver and go for it 😃
Pedals are just a couple uggas, until they’re tight, no precise torque needed. More important to make sure you grease the threads, or use anti-seize grease, so they’ll come back off.
I doubt it actually matters. 30 Nm is just a typical torque for the pedal thread, so that’s what they give you.
What you want to do is grease the threads well, take any pedal wrench and make it kinda tight.
Grease the threads and make it tight. Done.