Lock on grips are great, but overtime you begin to lose the little bolts (M4x10mm) that hold the locking clamps in place. I went to the three largest hardware store chains on the mid Atlantic region, Home Depot, Ace Hardware, and Lowe’s, and only found socket head bolts that had these big knurled heads that don’t fit inside the clamp.
Jensen has the bolts for ODI lock on grips but I understand those are sized a little differently.
I found some ridiculously expensive ones anywhere from 2 to 4 dollars a bolt on AliExpress but I need titanium ones like I need a hole in the head. Stainless steel would be fine.
Does anyone have a good resource?
by Returning2Riding
3 Comments
McMaster Carr
Mcmaster that bastard, measure the diameter of the pocket though as button head screws come in some variance, also you can buy aluminum or titanium from McMaster and shed a few grams while youre at it, remember to use a bit of temporary thread locker.
Like u/brendax says go to McMaster Carr’s website on a desktop computer and use the filters on the left side of the screen. Have a measuring device handy to check your requirements.