I've been scouring this sub and seen some people say to tap the axle out after getting the end caps off and others saying to put the freehub in a vice and yank the wheel up. I can't tell what I should do next to remove the freehub body. This is a stock hub from vision team 30 wheels from 2022. Tia!
by lunar_alpenglow
1 Comment
Tap the axle, but protect it with a piece of wood or hard thick plastic. Don’t hammer directly on the axle until it breaks free. At that point it’ll just take a few more gentle taps to remove if you haven’t already blasted it out the other side.
I should add that you should remove the non drive side bearing first so you can see what type of bearing setup is on the other side. If you have an exploded view you can make a decision based on that but if not, tap out the NDS bearing and then investigate.