(Apologies for the repost – I encountered some formatting issues)
How to remove this type of freehub body?
In a previous post, I demonstrated the sound this hub makes, and now that I have the necessary cone spanners, I decided to take it apart. I removed the non-drive side end cap, but the hub axle only comes out as far as shown in the picture. The freehub body doesn’t move at all.
The wheel is an Alexrims GR2.3, and the hub has an unknown Cube branding. The markings on the freehub body are unreadable due to wear.
by kri1st
2 Comments
A link to previous post: [https://www.reddit.com/r/bikewrench/comments/1ig43gg/noisy_freehub/](https://www.reddit.com/r/bikewrench/comments/1ig43gg/noisy_freehub/)
Not quite sure, but you should remove the brake rotor to better access the hub!