The cog moves other then that it works pretty good not sure if I need to replace a part or smth.
I have tried to tighten the lock nut even more but it doesn’t work.
by badsam112
The cog moves other then that it works pretty good not sure if I need to replace a part or smth.
I have tried to tighten the lock nut even more but it doesn’t work.
by badsam112
3 Comments
I think that’s how it free coasts backwards.
Just the clutch disengaging. It’s fine. Clean it up and grease it.
That appears to need some adjustment. The clutch disengaging should not allow for the driver to back out of the drive side bearing. Loosen the non-drive side jam bit, engage the driver into the clutch, adjust the drive side jam nut to where there’s no play, but no binding, then adjust the non-drive side jam nut in a similar fashion.