Can I please have opinions on this!?
Used the Holy Diver decal to use to align the badge and although I’m pleased with it, thinking of using a sharp blade after lifting the decal up at the edges, and cutting the excess off?
Would this be possible/worth doing!?
by Edifice66
9 Comments
That badge is rad but kinda takes away from it with the decal creeping out. Lots of work for some headtube art but if you’re into it, the badge will look really good without anything creeping out the sides.
Gonna get on it then with a brand new Stanley blade later, and be very careful not to scratch my frame!!!
Is the decal painted over? If not use a heat gun or hairdryer & some GooGone to remove it.
No, it’s just stuck on the frame so am gonna peel each part to the edge of the badge and use a scalpel to ”trim” off the excess and yeah, as you say then remove the residue!!!
Thinking about it, would’ve made more sense to have removed the entire bottom half of the decal first before then using the 3 points of the shield on the decal to align the badge!? 🤔🤔🤔
Just a balled accent
1. Take off badge
2. Remove sticker
3. Replace badge
Don’t make it harder than it needs to be.
You should take it off and then remove the sticker and then put it back on because it looks like shit.
Wow this post somehow gets stupider as I go along.