Hey there, my friends pedal has just fallen off mid ride from a Marin bike he bought off bikes online. Not sure if the crank is stripped or if we can put it back on. Does this warrant getting in contact with Marin or bikes online?
Yes you stripped the threads on the crank. You could try to get it re threaded but for the trouble/cost u probably should just get a new crank arm
Sorry didnt read the post fully, the installation was bad. Get them to replace
SspeshalK on
It’s stripped – the only repair choices are a helicoil or replace the crank arm. It doesn’t look like there’s any chance of repairing the threads.
I doubt the seller will help – the bike probably came without the pedals fitted so they’ll blame the installation. No harm in trying I suppose.
ligonier77 on
One thing that sometimes works is to thread the pedal in from the back side of the crank using the few good threads left. As it moves in it will refresh the threads that were stripped. Then you can remove the pedal and carefully thread it in the right way. Not sure that will work in this case because there’s a lot of damage.
dano___ on
Bikes don’t ship with pedals installed, whomever installed that pedal didn’t tighten it properly. The threads are pretty trashed, I wouldn’t trust them anymore. If a shop near you can helicoil it you might save a few bucks, otherwise you’ll have to replace the crankarm.
DubyaEl on
A little bit
Sparroka on
Thanks for the help everyone. We’re going to go to the bike store and get it rethreaded
boopiejones on
I’d throw those away. You can get a nice set of used, high quality cranks for less than the cost of a repair.
darb85 on
Well it ain’t fixed….
ThisOldGuy1976 on
Yup
Reinis_LV on
Wait, it happened on your drive side? Thats odd. It always happens on non drive side because of how thread can get loose.
TheDaysComeAndGone on
Your threads failed. Either because somebody forced a left side (left-handed thread) pedal on the right side or because of too much or too little torque (probably the later).
11 Comments
Yes you stripped the threads on the crank. You could try to get it re threaded but for the trouble/cost u probably should just get a new crank arm
Sorry didnt read the post fully, the installation was bad. Get them to replace
It’s stripped – the only repair choices are a helicoil or replace the crank arm. It doesn’t look like there’s any chance of repairing the threads.
I doubt the seller will help – the bike probably came without the pedals fitted so they’ll blame the installation. No harm in trying I suppose.
One thing that sometimes works is to thread the pedal in from the back side of the crank using the few good threads left. As it moves in it will refresh the threads that were stripped. Then you can remove the pedal and carefully thread it in the right way. Not sure that will work in this case because there’s a lot of damage.
Bikes don’t ship with pedals installed, whomever installed that pedal didn’t tighten it properly. The threads are pretty trashed, I wouldn’t trust them anymore. If a shop near you can helicoil it you might save a few bucks, otherwise you’ll have to replace the crankarm.
A little bit
Thanks for the help everyone. We’re going to go to the bike store and get it rethreaded
I’d throw those away. You can get a nice set of used, high quality cranks for less than the cost of a repair.
Well it ain’t fixed….
Yup
Wait, it happened on your drive side? Thats odd. It always happens on non drive side because of how thread can get loose.
Your threads failed. Either because somebody forced a left side (left-handed thread) pedal on the right side or because of too much or too little torque (probably the later).