I bet myself I could get my wheel off first try and I spent Five minutes just mentally preparing myself for this. I once took I hiatus from BMX and couldn’t figure out why the wheel wasn’t coming off. These have reverse threads on the RHD and I was tightening it down and close to getting the breaker bar.
Essentially Demolition cassettes tighten themselves as you grind. That being said I have to dial my chain in with a half link master link and to insure less slippage or uneven placement of the axle, I will be lodging pedal pins in the dropouts of the frame to eliminate voids.
TL;DR
Woodworker stares at socket wrench in denial of dementia
by lumbirdjack
2 Comments
On the left hand side is it lefty… tighty. Tbh it wasn’t necessarily an awful idea, but it wasn’t really needed and you could be screwed for stripping the wheel nut as who has opposite thread wheel nuts in stock?!
Is that the anorexia hub? I had that a while ago and I had nothing but problems with it. Especially the bearings, they would explode when I would try to grind. I went through 3 sets before I gave the wheel away. Not to mention it would skip a lot, not as bad as my old shadow symbol hub but it was close