I still cant understand how adding a relay would improve starter motor.
Edit: sorry I was interrupted before finishing my comment/question above. Anyway, what I meant was the starter was already connected to batt directly, so what would be the benefit/boost gained by adding a relay in-between them since a relay would not boost them unlike a cap/condenser?
This makes no sense to me. You have two wires going to the solenoid from the 4-pin relay. Why? If Pin 86 is ground, then Pin 85 turns on the 4-pin relay, so it should be from the Ignition switch, terminal C (for Crank). Pin 30 has the 12v from the battery just waiting to get sent on pin 87 (back to the solenoid?) I don't think so. I'd send pin 87 to your electric choke on the carburetor or to the petronix electronic coil.
16 Comments
It is Useful for me 🙏
This is easy way example❤
thank you I'm busy wiring my car and thus is very helpful. ❤
For by pass which two wire
May i know..wire to alternator? And also starter to battery?
86 pin is from ground? To ground?
Solenoid Red wire,,,To battery? From battery?
How could you by bass the ignition on the starter and run a button to ingage the starter after turning the key to run
I see 30 is constant, and 87 sends 12v to solenoid, but 85 is from ignition switch?
Does anyone provide a kit for this?
I still cant understand how adding a relay would improve starter motor.
Edit: sorry I was interrupted before finishing my comment/question above. Anyway, what I meant was the starter was already connected to batt directly, so what would be the benefit/boost gained by adding a relay in-between them since a relay would not boost them unlike a cap/condenser?
Just vibin with the starter relay (pretty chill here)
This makes no sense to me. You have two wires going to the solenoid from the 4-pin relay. Why? If Pin 86 is ground, then Pin 85 turns on the 4-pin relay, so it should be from the Ignition switch, terminal C (for Crank). Pin 30 has the 12v from the battery just waiting to get sent on pin 87 (back to the solenoid?) I don't think so. I'd send pin 87 to your electric choke on the carburetor or to the petronix electronic coil.
Where's the ignition switch?
are 85 or 86 going to w04k either way as long as 30 gets a 12v and 87 goes to device?
depends in a NO or NC curcuit
Salom salom ❤❤❤❤❤
This makes no sense. There's no ignition switch