For any parent whose child is learning to ride on a Woom
GO 1, this may help if their hands are too small to comfortably reach the brake lever follow these instructions to insert a 1" machined screw for brake handle position adjustment:
-
Loosen the rear brake cable screw.
-
Add a little cable slack.
-
Insert a 1-inch machine screw into the lever hole to bring the brake lever closer.
-
Re-tighten the cable screw.
-
Adjust the brake so there is about a credit-card-sized gap on both sides.
by PocketsWithHoles
2 Comments
Just fyi, this applies to almost every brake. It’s called reach adjustment.
If that barrel adjuster on the brake lever weren’t bottomed out you could adjust the cable from there. When I setup new brake I usually back it out a couple turns.