I can’t get the second bearing out. I followed instructions, but it seems that the 6902 bearings will not fit through the ratchet ring (photo 2), on the other side there is also something blocking it. Is there still something I should remove?
by csldgr
3 Comments
I had the same issue a couple of weeks ago. The bearing is held in place with a circlip from the outer side. I couldn’t remove the circlip because it was too rusted so I just bought a new freehub body.
You see those two little tabs that are sticking out – that’s a circlip. You need to remove that circlip to then get the bearing out.
Either get a set of long nose circlip pliers or a pick to release the circlip and the bearing will drift out from there.
Jusr buy the freehub as is. It comes with bearings.