Ive tried to install new brake pads as my old ones were worn way past the wear line. The ones I've installed are the same type but I'm having some issues with the tightness. I've tightened them to the point where they're basically rubbing against the rim (not ideal, i know) but I still need to pull the brakes back basically to the bike handle for anything to happen. What have I done wrong?
by deathofaspatula42
2 Comments
Either the cable is not routed properly or you didn’t pull both callipers in when tensioning. If it is neither of those then something is likely damaged.
Check to see if the cable housing popped out of the cable guides on the frame anywhere
Something is wrong with the conical washer setup on the new pads’ posts. Things aren’t even, the washer spacing should be the same on both sides. I can’t really tell from the photos, but some might be missing too.