This stem uses a wedge that ITM called the grip wedge system. I showed a pic of the one in the stem that clamps the steerer, but I’m still missing one from the bar clamp. It’s metal, not plastic, and I don’t know if 3D printing one would be sturdy.
I’ve tried reaching out to the original ITM company, and the new Taiwan company that they became. The new company has one for sale for a newer model of stem, but I’m unsure if the dimensions are the same and it’s almost $60 before shipping.
How can I find, source, or get one of these made? Do you have one? I’ll pay you well for it + full shipping.
by tt331517
2 Comments
I would use the shim you have on the bars to make sure it fits there then start measuring. The company that has the new one should be able to send you accurate dimensions of it so you can verify the fit.
$60 is expensive but might be your only option.
Following. I also need a compression wedge for a selle italia monolink seatpost and have not been able to find one anywhere
https://preview.redd.it/f72et62q6qdg1.jpeg?width=1080&format=pjpg&auto=webp&s=1fbc7b52831303b2cee281b6c69907382f716e2b