I noticed my rear hub bearing needed replacing, so tapped it out. Discovered why it needed replacing: the outer piece had broken in half longways. Like, broken into two rings!
But now I have half out, as you see in the photos. And the other half is still stuck in the hub, with nothing to push against from the other side, to get it out. Hard to see in the photos though.
Any suggestions for how to get the remaining ring out?
Cheers from New Zealand, and happy new year.
by Rain_on_a_tin-roof
1 Comment
Needs a blind hole bearing puller set with a slide hammer. Should be able to catch the backside of that broken race to pull it out. Probably shouldn’t be too hard since there’s a good 40% less surface area engaging the hubshell lol.