Made a copy of a bunch bar. Usually such complex products require special equipment and complex moulds. So this project was a challenge for me to do at home. My goal was to make it as good as possible. it took a lot of effort, but the result was worth it. My version is a bit wider than original bunch bar. 300mm hoods, 350mm drops
by lordofeternity_
6 Comments
Short video about it
[https://www.instagram.com/reel/DQ3qYmaDJIT/?igsh=ZGw4OHAwNHN4eWVz](https://www.instagram.com/reel/DQ3qYmaDJIT/?igsh=ZGw4OHAwNHN4eWVz)
Man did it again
You should make some more then. IT’S AWESOME
Looks amazing, although I would say it is too sharp for my liking. I tend to rest my hands on the top of my bullbars from time to time. This would not work for that position.
Is it even possible to be wrapped? Resin used with carbon doesn’t like sweat, if I remember correctly.
Normally not into carbon, but boy that thing is sexy. Great job.
What I think I saw you in Russian show lone rider