Notice this after a ride. Ran these at 27psi and it’s my rear. No issues in the front but the back has some sealant leaking from the tire, is this normal?
by sb_3145
Notice this after a ride. Ran these at 27psi and it’s my rear. No issues in the front but the back has some sealant leaking from the tire, is this normal?
by sb_3145
6 Comments
Yes
No. That’s brutal.
Normal if it’s Stans but that’s why I use and sell Orange Seal. And even more seriously than that you should check out the “Vittoria tire pressure calculator” 27psi just kinda sounds low unless you’re 140lbs. Sort of wondering if you weren’t sort of slowly burping the bead on your ride
For hooked, No. I have no experience with hookless.
Maybe, assume seated good? I wouldn’t stress unless goes flat within 24 hours
Looks like you’ve been burping the tyre, if a sidewall is thin or not enough tyre pressure the tyre can roll off the rim slightly and burp on hard cornering. Sealant around the bead is a sign of this happening. It’s not an issue, I’d just run a little more pressure in the rear.