hey everyone! pretty new to cycling in general but eager to jump in.
I picked up this used bike in pretty good condition from what I can tell.
Orbea Avant H60?
Need to get a new stem and saddle but I am not sure on the measurements needed. Anyone know a quick way to figure that out other than measuring?
I used to be an avid fixie rider, but I am venturing into what feels like new territory now. I appreciate any tips or advice!
by No-Onion2524
4 Comments
Was it literally just being thrown away
Looks like a trainer tire on the rear, check the stem, bars and headset for excess corrosion
Quickest way is to measure the seat tube inner diameter, then buy a seat tube off ebay the same size. Saddle is whatever you fancy, same for stem length/design, but measure the bar diameter.
27.2mm seatpost
1-1/8″ / 31.8 stem
The length of the seatpost and stem is variable. 350mm seatpost and 100mm stem would be standard.
The rear tire should be changed before riding on road. I would recommend changing the bar tape, and inspecting the headset, bars and shifters for corrosion.