I just trued my rotors and got them relatively straight (run out less than 1mm).
However, it looks like I just left a bit of dimple here where I’ve circled.
Any smart way to even that out or should I leave it alone?
by dsocohen
I just trued my rotors and got them relatively straight (run out less than 1mm).
However, it looks like I just left a bit of dimple here where I’ve circled.
Any smart way to even that out or should I leave it alone?
by dsocohen
5 Comments
Cosmetic damage to the cooling fin. Non-issue.
Smack or press it with something. It’s just metal.
If the contact area is true, leave it alone.
Nothing to worry about. Won’t affect performance in any way.
Damn, what were you truing the rotor with?
I just do this by hand. It works fine and you’ll never damage your rotor.