For some reason, both sides of my rear rack are tapered in equally where the roller mounts. This does not appear to be a defect of the rack.
This taper causes the included screws to sit cockeyed when tightened down as shown.
On the pictured side, because the screw is cockeyed, the wheel binds when the nut is tightened because the washers are cocked at an angle and cause drag on the wheel.
Does anyone have any suggestions on how to resolve the cockeyed screw issue?
1 Comment
For some reason, both sides of my rear rack are tapered in equally where the roller mounts. This does not appear to be a defect of the rack.
This taper causes the included screws to sit cockeyed when tightened down as shown.
On the pictured side, because the screw is cockeyed, the wheel binds when the nut is tightened because the washers are cocked at an angle and cause drag on the wheel.
Does anyone have any suggestions on how to resolve the cockeyed screw issue?