Hi everyone,
Recently bought new Nimbl Exceed Pro, after finally getting them I set out to install new Look Keo grip cleats onto them.
After checking the right orientation and looking up what specs (e.g nm and any other instructions, as Nimbl does not provide them) I’ve went to install the cleats with a bit less than 5nm onto the shoes:
– both sides a very feint creak (happend before on other shoes, did not think anything about it
– one bolt kept turning after 5nm with no resistance
After removing the cleats on both shoes I saw a bit of delamination on both sides, see pictures..
What do you think? Cosmetic or more? Already contacted Nimbl but they apparently are quite slow in responding..
P.s. used a torque wrench and assembly paste – maybe the wrench is kaput so I ordered a new one, but on my old shoes it works just fine
by juxtaposet