So I usually just tape the dynamo wire to my fork. Then I realized I could zip tie it, but the zipties sometimes (just once) slid down but more importantly, I didn't like the way it looked.
So I 3d printed this stupid pink zip tie holder and bolted it.
That way, I can reuse my tiny ass zipties.
by strip_club_food_yum
7 Comments
i usualy just use R clamps from feners, but I appreciate you
What else do people even print?
🤣 I was ‘solving’ a problem for my gf this weekend and realized how overly complicated I was making things with prints. With that said my bikes are covered in prints.
Good work, ride safe!
That’s rad. Also what did you encase the dynamo wire in? I’ve never seen that
I feel like the hole could be smaller to beef up the top and bottom of the supports. Looks like they’d break if you leaned the bike in the wrong place. Plus I personally would try to add some curve to wrap the fork a little bit so its pulled in closer. Looks great nonetheless!
Pretty sure that elkhorn rack has internal wiring at the bottom no? Or is that just at the rack
I use shrink tubing to hold dynamo wire in place, but… you do you
nice